Digital Instruments SYNC-SWITCH Provozní pokyny

MCO-5211 Master Sync Change-over Guide to Installation and Operation M3006-9700-100 4 October 2013

6 | MCO-5211 3.2 Jumpers 3.2.1 PP1 - Audio Beeper The audible alarm can be programmed to three different functional modes using jumper PP1. Jum

MCO-5211 | 7 To reset the alarm relay, press: HOLD TO MODIFY plus MANUAL or HOLD TO MODIFY plus SYNC GEN. 1 or HOLD TO MOD

8 | MCO-5211 4 Operating Instructions Fig. 4-1 Front of the Instrument 4.1 Front Panel Indicators REMOTE A yellow LED that indicates tha

MCO-5211 | 9 4.3 Rear Panel Connections The figure shows the base unit with four BNC channels, and the positioning of factory-installed o

10 | MCO-5211 XLR connector panels XLR connectors are used for output of the balanced signal channels of the changeover. These channels are only av

MCO-5211 | 11 Pin Function and Value Comments 6 Output 0: Fault on sync generator 1 1: No fault on sync generator 1 Error status flag for

12 | MCO-5211 5 Technical Specifications BNC Channels (Basic and MCO-OPT-8617 option) Connector: BNC 75 Ω Return loss: > 36 dB, 0.1 to 10

MCO-5211 SAFETY COMPLIANCE This equipment complies with: EN 60950-1 (2nd edition) directive 2006/95/EC CSA C22.2 No. 60950-1 (2nd edition) UL 60950-

MCO-5211 Table of Contents 1 Introduction and Applications ...

MCO-5211 . How to contact us: For technical assistance, please contact the Miranda Technical support center nearest

MCO-5211 | 1 1 Introduction and Applications 1.1 Introduction The MCO-5211 Master Sync Change-over is designed to be used with a pair of MS

2 | MCO-5211 1.3 Configuration The basic MCO-5211 Changeover includes four identical 75Ω channels with BNC connectors. Two available options, the

MCO-5211 | 3 2 Safety 2.1 Safety Characteristics This apparatus has been designed and tested in accordance with the Safety Class 1 requirem

4 | MCO-5211 WARNING: Make sure that only fuses of the required rating, correct voltage, and the specified type are used for replacement. The use o

MCO-5211 | 5 3 Configuration 3.1 General Information Some key functionality of the MCO-5211 change-over is programmed by the use of jumper p